PeakTech 2170 Bedienungsanleitung Seite 60

8. Measurement
8.1. Inductance measurement
1. Turn on the power.
2. Insert the measured inductance into the input terminal
directly or:
3. Connect the alligator clips to the ends of the measured
inductance
4. Insert "Open" Adapter to direct measurement sockets
5. The default test mode is Auto LCR mode, the inductance
value will be show on primary display and the quality factor
Q will show on secondary display. In Auto LCR mode, the
D/Q/ESR key, SEL/PAL key, SORTING key and REL%
key are not available.
6. Press FUNC. key to select Auto-L mode. The primary LCD
display will show the inductance value. The secondary
LCD display will show the quality factor Q. The equivalent
resistance ESR/Rp，phase angle θ or dissipation factor D
can also be shown by pressing the D/Q/ESR key.
7. Press FREQ key to select frequency value: 100/120
Hz/1/10/100 kHz.
8. Press SER/PAL key to select series or parallel mode.
60