Attaching The Unit; Storage - Wilo Atmos TERA-SCH Serie Einbau- Und Betriebsanleitung

en
Fig. 8: Attaching the pump
5.2.2

Attaching the unit

Fig. 9: Attaching the unit
5.3

Storage

18
Transport and storage
load-bearing elements are loaded vertically. If necessary, use a lifting arm, to which
the lifting gear can be vertically attached.
ƒ
Ensure that the load is lifted vertically!
ƒ
Prevent the suspended load from swinging!
ƒ
Comply with applicable national safety regulations.
ƒ
Use legally specified and approved lifting gear.
ƒ
Select the lifting gear based on the prevailing conditions (weather, attachment
point, load ...).
ƒ
Only attach the lifting gear to the attachment point. Fix in place with a shackle.
ƒ
Never feed the lifting gear over or through transport lugs without protection.
ƒ
Never feed the lifting gear over sharp edges without protection.
ƒ
Use lifting equipment with sufficient bearing capacity.
ƒ
The stability of the lifting equipment must be ensured during operation.
ƒ
When using hoisting gears, ensure that a second person is present to coordinate the
procedure if necessary. For example, if the operator's field of vision is blocked.
ƒ
The safety and efficiency of the lifting gear is best guaranteed when all load-bearing
elements are loaded vertically. If necessary, use a lifting arm, to which the lifting
gear can be vertically attached.
ƒ
Ensure that the load is lifted vertically!
ƒ
Prevent the suspended load from swinging!
NOTICE
Improper storage can lead to damage to the equipment.
Damage caused by improper storage is not covered by the guarantee or warranty.
ƒ
Requirements at the storage location:
–
dry
–
clean
–
well-ventilated
–
free from vibrations
–
free from humidity
–
free from rapid or extreme changes in temperature
ƒ
Store the product somewhere safe against mechanical damage.
ƒ
Protect the bearings and couplings from sand, gravel and other foreign objects.
ƒ
Lubricate the unit to prevent rust and bearing seizing.
ƒ
Manually rotate the drive shaft several times once a week.
WILO SE 2020-10