While The Sauna Is In Operation; When The Heating Time Has Lapsed - Sentiotec CV 4 Gebrauchsanweisung

Operating instructions for the user - Figure 8
8

While the sauna is in operation

Programmed values can be checked and modified
while the sauna is in operation.
Checking desired values
1. Use the UP / DOWN buttons 7 to scroll to the
desired menu item, e.g. TEMP.
The current temperature will be displayed.
2. Press OK 6.
The programmed target temperature value will be
displayed.
The current temperature will be displayed after 20
seconds.
How to change desired values
1. Use the UP / DOWN buttons 7 to scroll to the
desired menu item, e.g. DURATION.
The remaining heating duration will be displayed.
2. Press OK 6.
The display 5 indicates:
SAUNA
Duration
3. Use the UP / DOWN buttons 7 to enter the new
value, e.g. [01:30].
4. Press OK 6.
The new heating duration is accepted and the
remaining heating duration will be displayed.
Ending automatic operation early
1. The START / STOP button 8 turns OFF the au-
tomatic sauna operation.
The signal lamps (8 / A) turn off.
38
9
When the heating time has lapsed, a signal will sound
and the display 5 indicates the following:
The programmed values will be saved in the control
until they are changed.
Turning off the control
1. Press ON / OFF button 3.
2. Turn off the ON / OFF switch 1. The control unit
After automatic operation has lapsed, it will have to
be activated again for a new sauna bath.
SET
previously selected
heating duration,
e.g. 02:30

When the heating time has lapsed

SAUNA OFF
Duration STOP
The display 5 indicates:
- - - -
will be disconnected from the mains.
The sauna control is turned off.
NOTE: