Manual Operation Quick-Start - Sentiotec CV 4 Gebrauchsanweisung

Operating instructions for the user - Figure 8
5

Manual operation quick-start

After setting the time according to chapter 3, the control
is ready-to-operate.
1 Turning on the control
1. Turn on ON / OFF switch 1.
If the display 5 indicates:
- - - -
Press ON / OFF button 3.
The display 5 indicates the
last condition displayed, e.g.:
SAUNA
Parameter
2 Selecting sauna operation (with CV F4 only)
Press sauna button A.
3 Entering the heating duration
Note - Heating duration
The heating duration of the sauna control can be set up
to a max. of 6 hours.
1. Use the UP / DOWN buttons 7 to scroll to
DURATION.
2. Press OK 6.
The display 5 indicates, e.g.:
SAUNA
Duration
or the value set previously.
3. Use the UP / DOWN buttons 7 to enter the desi-
red value, e.g. [02:30].
4. Press OK 6.
The display 5 indicates:
SAUNA
Duration
After approx. 1 second you will see:
SAUNA
Duration
The heating duration has been set.
5
5. Press START / STOP button 8.
6. To exit:
6.1 Manually:
OFF
value
6.2 Automatically:
4
1. Press ON / OFF button 3.
2. Turn off ON / OFF switch 1. The control unit is
SET
06:00
If you have used the ON / OFF switch 1 to turn off the
interior lighting, you'll be able to operate it only via light
switch 2.
SEND
02:30
OFF
STOP
Continued
The heater starts to heat instantly at the previously
entered values.
The display 5 indicates:
SAUNA ON
Duration 02:30
Both signal lamps are illuminated (at button 8
and A).
Press START / STOP button 8.
The sauna heater turns off.
The signal lamps (8 / A) turn off.
After the set parameter for heating duration has
lapsed, the sauna will automatically stop opera-
tion.
How to turn off the control
The display 5 indicates:
- - - -
The sauna control is turned off.
disconnected from the mains.
NOTE - Interior lighting
35