Programming Automatic Operation - Sentiotec CV 4 Gebrauchsanweisung

Operating instructions for the user - Figure 8
6

Programming automatic operation

NOTE - "High-speed run":
Pressing and holding the UP / DOWN buttons 7 trig-
gers a "high-speed run" after 5 seconds.
NOTE - "Timeout":
After 20 seconds without entering a command, the pre-
vious display will appear.
WARNING - Fire hazard:
Prior to turning on the sauna control and
when setting the automatic operation (sys-
tem turns on automatically after a fixed time)
make sure that no combustible objects have
been placed on top of the stove.
1 Turning on the control
1. Turn on ON / OFF switch 1, if it was off.
2. If the display 5 indicates:
- - - -
Press ON / OFF button 3.
The display 5 indicates the
last condition displayed, e.g.:
SAUNA
Parameter
2 Selecting sauna operation (with CV F4 only)
Press sauna button A.
36
6
3
1. Use the UP / DOWN buttons 7 to scroll to START
2. Press OK 6.
3. Use the UP / DOWN buttons 7 to enter the desi-
4. Press OK 6.
4
OFF
1. Use the UP / DOWN buttons 7 to scroll to DU-
value
2. Press OK 6.
3. Use the UP / DOWN buttons 7 to enter the desi-
4. Press OK 6.
Continued
Select start of heating [0 - 24 hrs.]
TIME.
The display 5 indicates, e.g.:
SAUNA SET
Start Time 00:00
or the value set previously.
red value, e.g. [18:30].
The display 5 indicates:
SAUNA SEND
Start Time 18:30
After approx. 1 second you will see:
SAUNA OFF
Start Time 18:30
The start time for heating has been set.
Selecting the heating duration [max. 6
hours]
RATION.
The display 5 indicates, e.g.:
SAUNA SET
Duration 06:00
or the value set previously.
red value, e.g. [02:30].
The display 5 indicates:
SAUNA SEND
Duration 02:30
After approx. 1 second you will see:
SAUNA OFF
Duration STOP
The heating duration has been set.