Changing The Clock Battery; Disposal - Sentiotec CV 4 Gebrauchsanweisung

Installation instructions for trained electricians only
8

Changing the clock battery

Figure 1
WARNING - Electric shock:
Disconnect all poles of the sauna control
from the mains and secure from unintentio-
nal switching on prior to opening the cover
of the housing.
1. Slightly push in safety lock 5 and remove the
cover of the housing 6.
2. Figure 2: Release six-pin flat strip wiring 3 and
remove from connector 2.
3. Carefully remove cover 2 from base of housing
7.
4. Replace battery (type CR2032) 9 for clock on
upper board.
5. Insert strips 3 of cover 2 into both holding fix-
tures 4 on the sides and carefully push down on
the base of housing 7.
6. Check function of both switches C. (On and off
position)
7. Figure 2: Push six-pin flat wire strip 3 on con-
nector 2 until you can hear the lock lever snap
in position (lock lever points downwards).
8. Fit the housing cover 6 on the base of the hou-
sing 7, rotate it downwards and push down on
it until you can hear it lock in position.
Check for secure fit of housing cover.
30
9

Disposal

Please dispose of packaging materials in accordance
with prevailing disposal regulations.
CAUTION - Environmental damage:
• All utilized materials are environmentally com-
patible; they are identified and they are
recyclable.
• Do not discard the unit in the regular household
trash.
Precious raw materials can be recycled if the
unit is properly discarded.
• Please contact your local municipality for
current waste disposal codes.
Make sure the unit you are discarding cannot be
used, so that it may not turn into a source of ha-
zard for children at play, for instance.