When First Turning On; Operating Modes - Sentiotec CV 4 Gebrauchsanweisung

Operating instructions for the user - Figure 8
3

When first turning on

The ON / OFF switch 1 completely separates the
control unit from the mains. An internal battery keeps
the saved settings and the time.
1 Entering the time [00:00 - 24:00]
The current time has to be set after starting the sau-
na control for the first time.
1. Turn on ON / OFF switch 1.
The display 5 indicates:
SAUNA
Time
(or an arbitrary setting)
2. Press OK 6.
The display 5 indicates:
SAUNA
Time, e.g.,
NOTE - "High-speed run":
Pressing and holding the UP / DOWN buttons 7 trig-
gers a "high-speed run" after 5 seconds.
3. Use the UP / DOWN buttons 7 to enter the desi-
red value, e.g. [18:00].
Press OK 6.
4
The display 5 indicates:
SAUNA
Time
After approx. 1 second you will see:
SAUNA
Time
The time has been set.
34
4
Sauna operation can be carried out manually (quick-
start) or automatically.
1
Sauna operation starts immediately with the previously
set values.
After the set parameter for heating duration has lapsed,
the sauna will automatically stop operation.
OFF
2
— — : — —
The sauna operation is started with programmed set-
tings (refer to chapter 6).
What can be programmed?
SET
After setting the time according to chapter 3, you will be
12:00
able to program the following functions:
1. Automatic
2. The start of heating
3. The duration of heating
4. The temperature
SEND
18:00
5. The fan speed,
OFF
18:00

Operating modes

Manual operation (quick-start)
Automatic operation:
to activate automatic operation,
from 0 to 24 hrs., e. g. [18:00] hrs.,
from 1 minute to 6 hrs., e. g. [02:30],
15 - 110 degrees Celsius, e. g. [95° C],
from 0 - 100 %, e. g. [50%].