Entering The Time; Sauna Cabin Lighting; Sauna Operation; Manual Sauna Operation, Quick-Start - Sentiotec Sawo CK31 Montageanweisung, Gebrauchsanweisung

4

Entering the time

The ON/OFF switch 1 completely disconnects the
sauna control unit from the mains. An internal batte-
ry keeps the saved settings and the time.
The current time has to be set after starting the sau-
na control for the first time.
4.1 Switching on the sauna control
1. Press ON/OFF switch 1:
- The LEDs C - F light up for approx. 5 seconds.
The LED TIME G lights up. (e.g. 12:00 hours)
-
12:00
- The LED of the previously selected bath, SAUNA
H or CLIMATE A lights up.
4.2 Setting the current time [0 - 24 hrs.]
1. Press PROG/OK 9:
The display 6 flashes:
12:00
or the time set previously.
The display 6 will flash for 20 seconds. You will
have to start to set the time within these 20 se-
conds because the adjustment mode will lapse
and you will have to select it again.
2. Use the UP/DOWN buttons 8 to enter the desired
value, e.g. [18:00].
Note - High-speed run of values entered:
Press and hold down the UP/DOWN buttons 8 to
trigger a high-speed run of the values entered after
approx. 5 seconds.
3. Press PROG/OK 9:
The display 6 stops flashing.
The time has been set.
Operating instructions for the user 9
5

Sauna cabin lighting

Note:
The cabin lighting can be turned on/off independent
of the sauna control function.
1. Switch 2 turns on/off the sauna cabin lighting.

Sauna operation

6 Manual operation, quick-start
6.1 Switching on the sauna control
1. Press ON/OFF switch 1.
- The LEDs C - F light up for approx. 5 seconds.
- The LED of the previously selected bath, SAUNA
H or CLIMATE A lights up.
- The display 6 indicates the current time
(e.g.16:30 hours):
16:30
6.2 Setting to sauna operation
1. Press Sauna H.
The LED of Sauna H lights up.
-
- The display 6 indicates the current time.
45