Activating/Deactivating Phase Alignment; Activating/Deactivating The Remote Start And Preset Time Function - Sentiotec Pro B3 Montage- Und Gebrauchsanweisung

Installation instructions, only for experts
8.2.

Activating/deactivating phase alignment

Phase alignment is activated or deactivated using the function selection switch 3.
● The function selection switch 3 is set to the ON position as standard. Phase
alignment is therefore activated.
● If you wish to deactivate phase alignment, place the function selection switch
3 in the OFF position.
8.3. Activating/deactivating the remote start and preset
time function
The remote start and preset time functions are activated or deactivated using
the function selection switch 4. The remote start and preset time functions can
only be activated and deactivated together.
● The function selection switch 4 is set to the ON position as standard. The re-
mote start and preset time functions are then activated.
● If you wish to deactivate the remote start and preset time functions, place the
function selection switch 4 in the OFF position.
EN 60335-2-53 states that sauna control units with a remote start and
!
preset time function may only be used with sauna heaters which satisfy
the combustion test described in paragraph 19.101 of EN 60335-2-53.
Alternatively, a suitable safety shut-off device can be installed in or
above the heater. Observe the information in the operating instructions
for your sauna heater.
WORLD OF WELLNESS
p. 26/38