Commissioning; Entering The Time [00:00-24:00] - Sentiotec O-Cv41 Montage- Und Gebrauchsanweisung

Installation instructions, for professionals only

7. Commissioning

Note Fig. 7 (figures chapter).
The sauna control unit is completely disconnected from the mains using the
operation switch
1
nal battery. After putting the sauna control unit into operation for the first time,
the current time must be set.
7.1. Entering the time [00:00–24:00]
1. Turn on the operating switch
The following appears in display 5: (or a random display)
SAUNA
Time
2. Press the OK button
The following appears in display 5: (or a random display)
SAUNA
Time e.g.:
3. Set the time with the plus/minus buttons
Press the OK button
4.
The following appears in display 5:
SAUNA
Time
After approx. 1 second the following appears in the display:
SAUNA
Time
The time has been set.
Tip – rapid change for input values!
After holding the UP/DOWN buttons
the input values start to change rapidly.
. The saved settings and the time are retained by an inter-
1
OFF
--:--
:
6
SET
12:00
:
6
SEND
18:00
OFF
18:00
: e.g.: 18:00
7
for approximately 5 seconds,
8
p. 17/34
EN