Setting The Preset Time - Sentiotec Pro D2i Gebrauchsanweisung

Instructions for use for the user

10.15. Setting the preset time

You can set the preset time to the minute. The maximum preset time totals 6 hours.
WARNING!
Risk of fire
Combustible objects that are placed on the heater will ignite and cause
fires.
● NEVER place combustible objects on the sauna heater.
● Make sure that NO combustible objects have been placed on the
sauna heater before you activate the preset timer function.
1. Start the function that is to be started after the preset time.
2. Select the preset time symbol 3 by pressing the mode button D.
► The display 1 shows the "hours" (flashes slowly).
3. Set the desired duration in hours with the plus button B and the minus button C.
4. Press the mode button D for about 3 seconds.
► The display 1 shows the "minutes" (flashes quickly).
5. Set the desired duration in minutes with the plus button B and the minus
button C.
6. Press the On/Off button A to start the set preset time.
► The sauna control unit changes to standby mode and the timer starts
running.
► The display 1 shows the remaining preset time. If this is longer than
1 h, the display shows hours (flashes slowly). If this is shorter than 1 h,
the display shows minutes (flashes quickly).
► The preset time symbol flashes.
► Once the preset time has elapsed, the selected functions are started.
The preset time can be exited by briefly pressing the mode button D
(without effect).
p. 57/70
EN