Maintenance And Repair - Bosch Rexroth PE 2 Montageanleitung

24/32

Maintenance and Repair

Bosch Rexroth AG, MIT: PE 2, 3 842 358 722/2015-05
10 Maintenance and Repair
High electrical voltage!
Danger of severe injuries or death due to electric shock.
Make sure the relevant system component is not under pressure or voltage
before performing any maintenance or repair work.
Protect the system against being switched on.
High pneumatic pressure!
Danger of severe injuries or death.
Switch off the compressed air supply on the relevant system component before
performing any maintenance or repair work.
Protect the system against being switched on.
Hot electric motor surfaces during operation!
Possible burns if the hot surfaces (over 65°C) are touched.
Provide appropriate safety devices to seal off the motors.
Let the system cool off for at least 30 min. before performing any maintenance
or repair work.
Unexpected movements, entering pallets
Injuries through lifting movements or through pallets entering the conveyor section.
Switch off the compressed air supply for the relevant system component before
pneumatically connecting, assembling or disassembling the product.
Make sure the relevant system component is not under pressure or voltage
before performing any maintenance or repair work.
Protect the system against being switched on.
• Continuous conveyors that are in motion or operation may only be inspected or
adjusted if protective devices are present and correctly positioned.
• Observe DIN EN ISO 13857 when removing or replacing protective devices and/or
deactivating safety devices.
• Test runs with open housings are only permitted when they are performed by
skilled workers using hold-to-run controls and when the infl uence of all other
switching devices can be excluded.
WARNING
CAUTION