Herunterladen Inhalt Inhalt Diese Seite drucken

Product-Specifi C Safety Instructions - Bosch Rexroth PE 2 Montageanleitung

Positioniereinheit
Inhaltsverzeichnis

Werbung

2.6 Product-specifi c safety instructions
The following safety instructions apply to chapters 6 to 14.
General
• Do not modify or convert the product.
• Do not expose the product to any mechanical loads under any circumstances.
• Always secure the product to prevent toppling.
• Observe the transport instructions on the packaging.
During transport
During assembly
• Check the product for visible transport damage.
• Lay cables and lines so that they cannot be damaged and no one can trip over
• Make sure the relevant system component is not under pressure or voltage before
• Protect the system component against being switched on.
• Before commissioning, make sure that all seals and caps for the screwed
• Let the product acclimate itself for several hours before commissioning, otherwise
During commissioning
• Make sure that all electrical and pneumatic connections are either used or covered.
• Check the safety requirements in accordance with DIN EN 619.
• Commission the product only if it is installed completely.
• Make sure that all safety equipment belonging to the product is present, has been
• Do not reach into moving parts.
• Check the product for malfunctions.
• Ensure that only authorized personnel do the following within the scope of
During operation
• Only allow persons who are authorized by the system owner to access the
• Make sure that
• Do not use EMERGENCY STOP command devices for routine stops.
• Regularly check the proper functioning of the EMERGENCY STOP command
• After an EMERGENCY STOP, in the case of a fault, or any other anomalies, switch
• Do not reach into moving parts.
• An idle system is not a safe system, as stored energy can be released
• After an EMERGENCY STOP or a malfunction, only switch on the system once the
EMERGENCY STOPS,
malfunctions
Never use the product as a handle or step. Do not place any objects on the
product.
them.
assembling the product or when connecting and disconnecting plugs.
connections are correctly installed and undamaged to prevent fl uids and foreign
bodies from penetrating the product.
water may condense in the housing.
installed properly, and is fully functional. Do not modify the position of, bypass, or
disable the safety equipment.
intended product use
– Start or operate the system, or intervene in its normal functioning
– Activate adjustment devices on components.
product's direct operating area. This also applies when the product is standing
still.
– There are no obstacles preventing access to the EMERGENCY STOP command
devices.
– All delivery points, workstations and passages remain freely accessible.
devices.
the product off and protect it against being switched on again.
unintentionally or through improper maintenance procedures.
cause of the fault has been determined and the error resolved.
Notes on Safety
3 842 358 722/2015-05, MIT: PE 2, Bosch Rexroth AG
9/32

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis