Recommissioning After Shutdowns; Operation; Notes On Operation; Wear - Bosch Rexroth PE 2 Montageanleitung

22/32

Operation

Bosch Rexroth AG, MIT: PE 2, 3 842 358 722/2015-05

8.3 Recommissioning after shutdowns

Follow the same procedure used for initial commissioning.
9 Operation
Hot electric motor surfaces during operation!
Possible burns if the hot surfaces (over 65°C) are touched.
Provide appropriate safety devices to seal off the motors.
Let the system cool off for at least 30 min. before performing any maintenance
or repair work.
Unexpected movements, entering pallets
Injuries through lifting movements or through pallets entering the conveyor section.
Switch off the compressed air supply for the relevant system component before
pneumatically connecting, assembling or disassembling the product.
Make sure the relevant system component is not under pressure or voltage
before performing any maintenance or repair work.
Protect the system against being switched on.

9.1 Notes on operation

9.1.1

Wear

• Wear is caused by the basic principle of this system and cannot be avoided on
individual components. By taking constructive measures and selecting proper
materials we strive to ensure that functional safety lasts for the lifetime of the
system. However, wear depends on the operating, maintenance, and ambient
conditions of the system and the location (resistance, contamination).
• Overloading the conveyor sections may damage the conveying medium and cause
the motor and gears to fail.
• Function cannot be guaranteed if the pneumatic components are overloaded.
9.1.2

Measures to reduce wear

The following measures reduce wear:
• Switch off conveyor sections when the system is not running, e.g. during breaks,
over night, on the weekend.
• Only select speeds that correspond with the particular function.
• Especially important: Avoid contamination by abrasive media; reduce
contamination through regular cleaning.
CAUTION