TERMA SOA Gebrauchsanweisung Seite 14

1. Insert heating element (1) into the threaded opening at the bottom end of the collector.
2. Twist the head of the heating element with a spanner no 22 until you feel resistance.
3. Special gasket (5) assures tightness of connection and allows an additional twist and correct positioning of the
front of the control head.
4. Put the radiator in an oblique position to make sure that the upper collector opening is in the highest point!!! The
radiator must not be rested on the heating element control head or any other part of the heating element unit at
any time!!!
5. Fill the radiator with the heating medium.
6. Put the radiator back in the upright position and check the level of the liquid inside it.
7. Make sure that the connection between the radiator and the heating element unit is tight.
8. Connect the device to electricity and turn on the heating element unit (upper collector opening must be open!).
8.1. One can use a hot heating medium of temperature not exceeding 65 C degrees for filling the radiator. In
such case, fill the entire radiator, put it in an upright position and turn the heating element unit on.
9. Set the maximum possible temperature and observe the liquid level rising – the excess liquid may be slopping
through the upper opening in the collector – remove excess liquid in order not to allow for the heating element
control head to be flooded or wetted.
10. When the level of the heating medium stops rising, wait another 5 minutes, turn off the heating element unit and
disconnect the device from electricity.
11. Do not wait until the radiator cools down and pour a small amount of the liquid out – to the mid width of the last
pipe.
12. Close the upper opening of the collector with the dedicated seal and put it back on the wall.
13. Connect the heating element unit to the socket / installation. The device is ready for use.
Downloaded from www.Manualslib.com manuals search engine