Safety Regulations - TERMA SOA Gebrauchsanweisung

Our products have been designed and manufactured in such a way to ensure that all the quality, functionality and
aesthetic requirements are met. We would like to congratulate you on this great purchase and wish You a pleasant
use.

SAFETY REGULATIONS

Please read the below instructions thoroughly and study the images carefully.
1. Never use the device that is damaged in any way.
2. Please check if the tally voltage equals the voltage of the electric installation in your home prior to connecting
the device.
3. Please check regularly if the power wire is not damaged and if the device can be used in a safe manner.
4. Power wire is not subject to repair. Damaged power wire should be replaced at the Manufacturer's or specialised
service centre.
For devices without the plug (ie. connected directly to installation), please see below colour codes for each wire:
5. Heating element is intended to work in a liquid medium environment. It is advised not to turn the device on in dry
conditions for longer than 5 seconds.
Do not touch metal parts – burning risk. Always make sure that the wire does not touch the heating element that
is hot.
6. The device must not be connected while being installed. Unplug the device or disconnect the power wire from
electrical circuit.
7. Do not open the enclusure.
8. Do not allow for the enclosure of the control head to get flooded or splashed with water or any other liquid.
9. Do not touch the electric device while standing in the bathtub, shower or barefoot on the floor.
10. Heating element's electric output cannot exceed 100% heating output of the radiator for the following
parameters: 75/65/20°C.
11. Pressure inside the radiator must not exceed the pressure value recommended by the radiator's manufacturer or
the pressure of 10 atmospheres for the heating element. Exceeding of recommended pressures may result in
the radiator or heating element damage and cause possible threat for health, life and property.
12. An air pillow of the correct parameters should always be allowed for inside an electric radiator (see →
Installation).
13. In case of a dual fuel radiator (connected to the central heating system) one of the valves should be left open
prior to turning the heating element on and during its operation in order for the excess water created due to its
heat expansiveness to be pushed out. Leaving both valves closed will result in excessive pressure growth which
may lead to damaging of the heating element or radiator (see → "Dual fuel radiator / Installation")
14. The device is intended for home use.
15. The device is not intended for use by children, persons with limited mental capacity or those who do not have
sufficient knowledge or experience required for handling this type of equipment. In such cases, control or
training by persons responsible for safety of the above mentioned is required.
Downloaded from www.Manualslib.com manuals search engine