Connecting The Interface And Power Supply Cables - Brother P-touch 9200DX Kurzanleitung

Connecting the interface and power supply cables

Connect the PT-9200DX to the computer according to the instructions below.
When connecting to the serial port:
Serial
1 Make sure that both the PT-9200DX and the computer are turned off.
2 Connect one end of the enclosed serial interface cable to the serial connector (IOIOI) of the PT-9200DX and the
other end of the cable to the serial port of the computer. For a Macintosh connection, connect the PT-9200DX to
either the modem or the printer port (preferably the modem port).
The serial (RS-232C) ports of some computers are shaped so that the serial interface cable cannot be con-
nected. If this is the case, use a commercially available adapter.
When connecting to the USB port:
You must install the software first before connecting to the USB interface or turning on the power. Please follow the
installation procedures on pages 12 through 21 before connecting up or turning the power on. The Brother P-touch
installation software will instruct you when to do this.
1 Connect one end of the enclosed USB interface cable to the USB connector (
end of the cable to the USB port of the computer.
Do not connect the PT-9200DX to the computer using both the serial and the USB interface cables, otherwise
the PT-9200DX may be damaged.
When making a USB connection through a hub, a proper connection may not be possible due to the type of hub
used. If printing is not possible with a hub connection, try connecting the PT-9200DX directly to the computer
using the USB interface cable.
2 Insert the power cord into the PT-9200DX.
3 Insert the power cord plug into an AC outlet equipped with a grounding terminal. Some locations may require the use
of an adapter provided with a grounding wire. Connect this wire to the ground terminal.
USB
) of the PT-9200DX and the other
3