With Windows® 2000 - Brother P-touch 9200DX Kurzanleitung

0 In the Install From Disk dialogue box, check that
"d:\English\ptouch\driver\pt9200dx\win98" (where
"d:" is the name of the drive containing the P-touch
Editor CD-ROM) appears in the "Copy manufacturer's
files from" box, and then click the OK button.
A In the next Add Printer Wizard dialogue box that
appears, select "Brother PT-9200DX", and then click
the Next button.
B The printer driver is copied onto the computer.
C A dialogue box appears, allowing you to select the
PTCOM port where the PT-9200DX is connected.
Select "PTCOM1:" if the P-touch is connected to the
COM1 port, or "PTCOM2:" if the P-touch is connected
to the COM2 port, and then click the Next button.
D In the dialogue box that appears, allowing you to
check the name of the printer, change the printer
name if desired, specify that this printer will not be the
default printer, and then click the Finish button.
E Remove the CD-ROM from the computer, select "Yes,
I want to restart my computer now.", and then click
the Finish button to restart the computer.
With Windows® 2000:
Installation should be performed in the following order:
(1) P-touch Editor Version 3.1
(2) Serial port monitor
(3) Printer driver
(1) P-touch Editor Version 3.1 installation
1 Install P-touch Editor Version 3.1 according to the
procedure described in P-touch Editor Version 3.1
Installation on pages 22 through 23.
2 After installation of P-touch Editor Version 3.1 is
finished, install the port monitor as described below.
The Port Selection dialogue box appears, but nothing
needs to be selected yet.
7