Using The Change Baud Rate Wizard - Brother P-touch 9200DX Kurzanleitung

R In the dialogue box warning that a digital signature
could not be found, click the Yes button.
S Remove the CD-ROM from the computer, select "Yes,
I want to restart my computer now.", and then click
the Finish button to restart the computer.

Using the Change Baud Rate Wizard

If the port where the PT-9200DX is connected does not sup-
port a baud rate of 115,200 bps, or if you wish to check the
connection between the P-touch and the computer, start up
the Change Baud Rate Wizard and select the desired set-
tings.
1 Selecting "Change Baud Rate Wizard" while installing
the serial printer driver will start up the Change Baud
Rate Wizard. Otherwise, the Change Baud Rate
Wizard can be started up by double-clicking its icon
in the P-touch Editor 3.1 folder.
2 In the Select Model dialogue box, select "Brother PT-
9200DX", and then click the OK button.
3 Select the serial port where the PT-9200DX is
connected, and then click the Next button.
4 Select the desired baud rate, and then click the Next
button.
Normally "115,200 bps" is selected; however, your
computer may not be able to support a baud rate of
115,200 bps. If this is the case, refer to the your
computer's instruction manual and select the maxi-
mum possible baud rate.
11