Starting The Equipment; Basic Adjustments At The Dip-Switch - JB-Lighting Varycolor 2000 Bedienungsanleitung

Varycolor 2000

Starting the Equipment

1. Set up of Varycolor 2000
Either set up your Varycolor 2000 on a steady base or hang up your Varycolor 2000 from the
bow assigned for. Take care that in any case all slits for ventilation are clear.
2. Cabling of Varycolor
Carry-out the cabling as follows:
Connect the output of your DMX-controller with the first Varycolor 2000 (controller DMX-out;
Varycolor DMX-in) with the aid of a 3pole XLR-cabel. Now establish the connection between
Varycolor with the aid of further 3pole XLR-cables. Make sure that in DMX-out of the last
Varycolor there is a resistor (XLR-plug with a resistance of 100 Ohm between pin 2 and pin 3)
plugged into.
3. Basic Adjustments at DIP-Switches
All DIP-switches "OFF": test mode (all functions of Varycolor 2000 are ran through)
DIP-switch 10 "OFF" 4 DMX-RESET off
DIP-switch 10 "ON" 6 DMX-RESET on
- 34 -