Occupation Of Connector Rows And Jumper; Changing Of Eprom/ Software Update - JB-Lighting Varycolor 2000 Bedienungsanleitung

Varycolor 2000
Occupation of connectors and jumpers
sketch connector
Pin/colour
dimmer1 1 orange
dimmer2 1 orange
colour 1 orange
effect 1 orange
gobo 1 orange
ventilator 1 free
AC-IN 1 black
DMX-IN/OUT 1 green
Change of Eprom/ Software Update
To change the Eprom proceed as follows:
Open the lid of Varycolor 2000. Now remove the right side-piece with the electronic card.
Remove the cover sheet for the electronic card by taking out the 4 screws (see sketch page
31). By comparing the electronic card with the plan of electronic parts (see sketch page 47),
you can see the Eprom at the bottom of the right side (IC U2). Carefully lever the used Eprom
from the holder and exchange it for a new one.
Direction:
Pay attention to the polarity of the Eprom!
(The inlet of the Eprom has to point to the same direction
as the inlet of the IC-holder.)
Now assemble your Varycolor 2000. Plug in your Varycolor and please test all functions.
Pin/colour Pin/colour
2 blue 3 red
2 blue 3 red
2 blue 3 red
2 blue 3 red
2 blue 3 red
2 free 3 black
2 black
2 red-white 3 beige
- 44 -
Pin/colour Stecker
4 yellow JP8
4 yellow JP9
4 yellow JP4
4 yellow JP3
4 yellow JP5
4 red JP7
JP6
4 black JP1