Unpacking Of Varycolor 2000 Equipment; How To Put In/ Exchange The Bulb; Adjustment Of The Bulb - JB-Lighting Varycolor 2000 Bedienungsanleitung

Varycolor 2000

Unpacking of Varycolor 2000 Equipment

Before you, you find the complete Varycolor 2000 equipment.
First of all take all parts from the carton. Check, if the delivery contains all parts.
Should you notice a damage through transportation, please immediately inform the carriers
respectively your dealer.
The packing of Varycolors will be used several times- if possible- because of conservation. In
case of returning packings you will get a part-credit.
Please make use of the return of packings within the meaning of our environment.
For this reason we ask for your comprehension, also in case of getting a used packing,
respectively inlay from us.
Put in/ Exchange of the Bulb
Warning: Before opening pull out mains plug!
Unscrew the bulb shaft at the back of the Varycolor with a suitable screw-
driver (compare to sketch page 31). Now put the bulb into your Varycolor,
subsequently screw the bulb shaft into the starting position.
Warning: Never touch the glass of bulb of the 200 MSD itself!

Adjustment of the Bulb

For adjusting the bulb please use the two screws marked as No. 1, with which the bulb shaft is
screwed tightly and the screws of silver marked as No. 4 (compare to sketch p. 31). Detach the
screws fixing the base sheet and try now with this sheet to place the bulb in the middle of the
reflector. Next turn the screw marked as No. 4 (compare to sketch p. 31), as long until the bulb
appears in brightest light and the illumination come up to it's optimum.
• Varycolor 2000
• Powercord without plug
• these operating instructions
- 33 -