Installation; Installing Or Changing The Lamp; Powering The Fixture - JB-Lighting Varyscan P3 Handbuch

2. Installation

2.1 Installing or changing the lamp

WARNING: Disconnect fixture from mains, and allow
!
Light source: OSRAM Baby-SharXS - HTI 250W/D5/80
Position head in horizontal position. Hinge no. 1 must be on the
upper side of the head. Turn screws no. 2 1/2 turn left and remove
plastic lid.
Loosen knurled head screw no. 3 and put up the lampcover.
Insert the lamp into the lamp holder. The nipple of the lamp
must face the top lid of the head. (See sketch).
If changing the lamp, remove old lamp from
lamp socket. Hold the new lamp only by its
ceramic base. Never touch the glass bulb.

2.2 Powering the fixture

WARNING: To ensure propper installation of the plug consult
!
Install a 3-prong grounding type plug that fits your supply.
Connected load: voltage 230 V, frequency 50 Hz
hot lamp to cool down for at least 30 minutes!
nipple
a qualified technician!
brown live
blue neutral
yellow/green ground
"L"
"N"
2
1
3
21