Control Panel Description; Starting The Oven; Cooking Chamber Preheating; Start/Stop - Whirlpool AFO ED4 DS Anleitungen Für Den Bedienungs-Und Wartung

4.0 CONTROL PANEL DESCRIPTION

1 ON-OFF button
2 Start-Stop button
3 Low ventilation speed
4 Time setting
5 Core probe setting
6 Temperature setting
7 Delta T setting
8 Chamber humidity
9 Phase setting
10 Go back/delete
11 Recipe's cookbook
12 Confirm
13 Increase value
14 Automatic washing
15 Decrease value
16 Manual decrease of humidity
17 Manual increase of hunmidity
18 Time/core probe display
19 Temperature/Delta T display
20 Recipe's display
21 Chamber humidity regulation
22 Recipe's phases

4.5 STARTING THE OVEN

When the oven is electrically suppliedIn the card is powered up. All the displays and led aren't light -
ened. Only the (1) ON-OFF key is lightened.
By pressing the ON-OFF key the card goes to READY mode.
In this mode the card is ready to set up and start a cooking cycle. ON-OFF led switches off.
If you pass in this mode the temperature's display shows for 5 sec the choose set (is lightened the dot at
the right of the last digit) and after it shows the measured chamber's temperature (the dot is not
lightened) . The visualization of the choose set (chamber or delta-T) is identified by the lightening of the dot
at the right side of the last digit. The displays of programs and temperatures and the led of humidity and
phases, carry the set up of the last manual cooking cycle's memorized. The lightened phases' led number
show the number of the phases of the selected program and the blinking phase's led shows which phase
is at present visualized.
If there are alarms they are shown in program's display and the buzzer sounds. At the first pressure of a
key the buzzer stop to sound. If it's possible the alarm's manual restore, it has done by a long pres-
sure of the key (10) . If there are no alarms and with a set up and confirmed the short pressure of the
START/STOP (2) key starts a cooking cycle and the card goes to START mode.
The card goes to STAND-BY mode with a long pressure of the (1) ON/OFF key.
4.5A COOKING CHAMBER PREHEATING
If you want to preheating the oven before start cooking, you have to set up 2 cooking phases: the
preheating and the cooking (you can obviously add new phases).The operations'sequence :
1. set phase 1, with PRE time and preset heating temperature.
2. You have to create the 2 phase
3. You have to modify the 2 phase with appropriates cooking time and temperatureb (the 2 phase can
be also core probe Δt type). After these operations the oven is ready to start.
By pressing the key (2) START/STOP, the oven starts without charge of cooking foodstuffs and goes
to the set up temperature in the 1 phase: when the set up temperature of preheating is reached, the
board sounds 2 bip.
1
2
18
19
21
20
11
13
15
16
5
EN
3
4
5
6
7
8
22
10
9
12
14
17