Washing; Switching Off; Alarms; Chamber's Probe - Whirlpool AFO ED4 DS Anleitungen Für Den Bedienungs-Und Wartung

EN

4.6 WASHING

Attention: you have to do this operation at the first installation Washing set up: by pressing the key
(14) washing one time and then a second time (long pressure), in display d appear ''set up''; after you
must press the key (2) start/stop to perform for about 2 minutes the charge of the soap.
Warning: SET UP will start up only if the oven chamber temperature is below 60º.
With the oven in READY MODE (ON/OFF led switched off) press the WASHING (14) key; Choose the
duration of washing between ''NORMAL, STRONG or EXTRASTRONG and RINSE with the ENCODER (13)
and then by pressing ENTER (12) to confirm your choice.
Pressing the key START (2) washing cycle start. WARNING: the washing cycle will start only if the oven
chamber temperatuer is 60º. By a long pressing of the key (2) START/STOP is possible to end the wash-
ing cycle. If the oven is not in START mode you may reset and go back by pressing the key WASHING
(14) and then the key CANC (ERASE, 10). If the washing set up or a washing cycle does not achieve good
results, it will be necessary to run a rinsing cycle or wash the oven manually. This operation is necessary
to prevent detergent traces from entering the cooking chamber during the following cooking cycles and
from coming into contact with the food.

4.7 SWITCHING OFF

To finish the cooking in every moment press the key (2) PAUSE/STOP. To switch off the oven press the key
(1) ON/OFF.

5.0 ALARMS

All the alarms are showed on display,

CHAMBER'S PROBE

With the card in READY, START or TEMPORARY STOP mode , if you see on display '' CHAMPR'' and you
hear the sound of the buzzer, there is a problem with the chamber's probe. If a cooking is carrying out, it
will stop immediately, and the card goes to READY mode. The buzzer stops by pressing every key. There
is an auto-restoring of the chamber's probe.

CORE PROBE

If the core probe has a problem, with the card in READY, START or TEMPORARY STOP mode, and the
current phase or one of the following ones, includes a CORE PROBE COOKING or a DELTA T COOKING, the
cooking stops and the card goes to TEMPORARY STOP mode. On display you see ''COREPR'' and the
buzzer sounds. The card doesn't go to ''ALARM'' or ''ERROR'' if it is in READY, FALL IN VOLTAGE or
STAND-BY. By pressing every key you stop the buzzer. The restoring is automatic when the core probe is
in function again (auto restoring).

SERIAL COMMUNICATION

If there is no communication between power card and keyboard for more than 10 sec., the keyboard
goes to ''ALARM'' or ''ERROR'': the buzzer sounds and you visualize ''COMSER''. The card doesn't go to
''ALARM'' or ''ERROR'' if it is in FALL IN VOLTAGE or STAND-BY. The carrying out cooking is stopped and the
card goes to READY mode. By pressing every key you stop the buzzer. The restoring is automatic when
there is communication again (auto restoring).

POWER CARD TEMPERATURE

If the temperature of the power card exceeds the value fixed by the producer, the power card goes to
alarm mode: you see on display ''TPCARD'' and buzzer starts to sound. The card doesn't go to ''ALARM'' or
''ERROR'' if it is in FALL IN VOLTAGE or STAND-BY. The carrying out cooking is stopped and the card goes
to READY mode. By pressing every key you stop the buzzer. The restoring is automatic when the
temperature returns under the fixed safety limit (auto restoring).

OPEN DOOR

In START mode, if there is an open door the card goes to TEMPORARY STOP and START/STOP led begins to
blink. Every carrying out cooking is stopped until the closing of the door.
9