Getting started
Setting the date and time
Set the date/time so that the correct date and time can be assigned to incoming calls, and to
enable the alarm to be used.
¤
Press the display key Time
or, if the date and time have already been set:
¤
Time
The active cursor position flashes
with
Enter date:
¤
. . . enter the day, month and year in 8-digit format with
e.g.
Enter time:
¤
. . . enter hours and minutes in 4-digit format with
e.g.
To save settings:
¤
Press the display key Save. . . . the message Saved is shown in
the display and you hear a confirmation tone
Returning to idle status:
¤
Press and hold the End call key
The telephone is now ready for use.
Connecting the headset
¤
Connect the headset with 2.5 mm jack to the left side of the
handset
For information on recommended headsets, see the relevant
product page at
The headset volume corresponds with the setting for the receiver
volume (
Connecting the USB data cable
For data exchange between the handset and PC:
¤
Connect the USB data cable with micro-USB plug into the
USB socket at the bottom of the handset
80
Downloaded from
www.Manualslib.com
. . . use
to select
OK
. . . switch between cursor positions with
for 07:15 .
.
1
www.gigaset.com/s850.
p. 115).
Connect the handset directly to the PC, not via a
USB hub.
manuals search engine
Settings
OK
Date/
. . . change cursor position
for 15/08/2014.
,
.
1
Calls
Time
Date/Time
Date:
15/08/2014
,
Time:
00:00
Back
1
1
Save