Transferring Data - Unify OpenScape S5 Base Bedienungsanleitung

Additional functions using the PC interface

Transferring data

¤
Launch the Gigaset QuickSync program on the computer.
The message Data transfer in progress is shown on the display during data transfer between
the handset and PC. During this time, it is not possible to enter any data using the keypad and
incoming calls are ignored.
Carrying out a firmware update
¤
Connect the telephone and the PC using a USB data cable (
QuickSync
¤
Start firmware update in Gigaset QuickSync . . . Information about this can be found in
Gigaset QuickSync help feature
The update process may take up to 10 minutes (not including download time).
The data are first downloaded from the online update server. The time required for this depends
on Internet connection speed.
The display on your telephone is switched off and the Message key
will flash.
Once the update is complete, your telephone will automatically restart.
Procedure in the event of an error
If the update procedure fails or the telephone no longer functions properly after the update,
repeat the update procedure:
¤
End the Gigaset QuickSync program on the PC
telephone
¤
Carry out the firmware update again as described above
If the update procedure fails more than once or it is no longer possible to connect to the PC, carry
out the Emergency Update:
106
Downloaded from www.Manualslib.com
Data transfer using Bluetooth:
•
The computer has Bluetooth capability.
•
A USB data cable is not plugged in. If a USB data cable is plugged in during an
existing Bluetooth connection, the Bluetooth connection is interrupted.
Establish connection to the handset
Do not interrupt the process and do not remove the USB data cable.
Remove the battery (
manuals search engine
Remove the USB data cable from the
p. 78) Replace the battery
p. 80) Launch Gigaset
and the Talk key