Manufacturer's Advice - Unify OpenScape S5 Base Bedienungsanleitung

The caller's number is not displayed.
•
Calling Line Identification (CLI) is not enabled for the caller.
network provider to enable Calling Line Identification (CLI).
•
Calling Line Identification Presentation (CLIP) is not supported or enabled by the network
provider.
•
The telephone is connected via a PABX or a router with an integrated PABX (gateway) that
does not transmit all information.
¤
Reset the system: Briefly pull out the power plug. Reinsert the plug and wait until the
device restarts.
¤
Check the settings on the PABX and activate phone number display, if necessary. To do
this, search for terms such as CLIP, calling line identification, telephone number
identification, caller ID, ... in the system user guide or ask the system manufacturer.
You hear an error tone when keying in (descending tone sequence).
•
Action has failed/invalid input.
guide if necessary.
You cannot listen to messages on the network mailbox.
•
Your PABX is set to pulse dialling.
No time is specified for a message in the call list.
•
Date/time are not set.
Registration or connection problems with a Bluetooth headset.
¤
Reset the Bluetooth headset (see headset user guide).
¤
Delete the registration data on the handset by de-registering the device (
¤
Repeat the registration procedure (

Manufacturer's advice

Authorisation
This device is intended for analogue phone lines in the UK and on the Irish network.
This device is intended for use within the European Economic Area and Switzerland. If used in
other countries, it must first be approved nationally in the country in question.
Country-specific requirements have been taken into consideration.
We, Unify GmbH & Co. KG, declare that this device meets the essential requirements and other
relevant regulations laid down in Directive 1999/5/EC.
The EC declaration of your country according to 1999/5/EC can be found at:
wiki.unify.com/wiki/Declarations_of_Conformity#Cordless_Phones.
This declaration could also be available in the "International Declarations of Conformity" or
"European Declarations of Conformity" files.
Therefore please check all of these files.
Downloaded from www.Manualslib.com
Ask the network provider to enable Caller Line Identification Presentation (CLIP).
Set the date/time.
manuals search engine
Repeat the process. Read the display and refer to the user
Set your PABX to tone dialling.
p. 108).
Manufacturer's advice
The caller should ask the
p. 109).
123