Setting The Date And Time; Connecting The Headset; Connecting The Usb Data Cable - Unify OpenScape DECT Phone S5 Base Bedienungsanleitung

Setting the date and time

Set the date/time so that the correct date and time can be assigned to incoming calls, and to
enable the alarm to be used.
¤
Press the display key Zeit
or, if the date and time have already been set:
¤
. . . use to select
Datum und Uhrzeit
The active cursor position flashes
with . . . switch between cursor positions with
Enter date:
¤
. . . enter the day, month and year in 8-digit format with
e.g.
Enter time:
¤
. . . enter hours and minutes in 4-digit format with
e.g.
To save settings:
¤
Press the display key Sichern. . . . the message Gespeichert is
shown in the display and you hear a confirmation tone
Returning to idle status:
¤
Press and hold the End call key
The telephone is now ready for use.

Connecting the headset

¤
Connect the headset with 2.5 mm jack to the left side of the
handset .
1
For information on recommended headsets, see the relevant
product page at www.gigaset.com/s850.
The headset volume corresponds with the setting for the receiver
volume ( p. 114).

Connecting the USB data cable

For data exchange between the handset and PC:
¤
Connect the USB data cable with micro-USB plug into the
USB socket at the bottom of the handset
Connect the handset directly to the PC, not via a
USB hub.
Einstellungen
OK
. . . change cursor position
for 07:15 .
.
1
Anrufe
OK
Datum und Uhrzeit
Datum:
15/08/2017
,
Zeit:
for 15/08/2017.
00:00
,
Zurück
Getting started
Zeit
Sichern
1
1
79