Eco Dect - Unify OpenScape S5 Base Bedienungsanleitung

ECO DECT

ECO DECT
The device range is set to maximum as default. This guarantees the best connection between
the handset and the base station. In idle status, the handset will not function (as it is not
transmitting). Only the base station will maintain contact with the handset via a low wireless
signal. During a call, the transmission power automatically adapts to the distance between the
base station and handset. The smaller the distance to the base, the lower the radiation.
To reduce the radiation further:
Reducing radiation by up to 80%
¤
Range
Deactivating radiation in idle status
¤
Radiation
100
Downloaded from www.Manualslib.com
. . . use to select
Change ( = off )
The range is also reduced with this setting.
It is not possible to use a repeater to increase the range.
. . . use to select
Change ( = on)
To benefit from the advantages of the setting No Radiation, all registered handsets
must support this feature.
If the setting No Radiation is activated and a handset is registered to the base that
does not support this feature, No Radiation is automatically deactivated. As soon as
this handset is de-registered, No Radiation will automatically be re-activated.
The wireless connection will only be established for an incoming or outgoing call and
the connection will be delayed by about 2 seconds.
In order that a handset can establish a wireless connection with the base station more
quickly for an incoming call, it must "listen" to the base station more often, i.e. scan
the environment. This increases power consumption and reduces the standby and
talktime of the handset.
When No Radiation is activated, there will be no range display/range alarm on the
handset. Contactability can be tested by attempting to establish a connection.
¤
Press and hold the Talk key
manuals search engine
Settings OK ECO DECT
Settings OK ECO DECT
. . . the ringing tone will sound.
OK Maximum
OK No