Registering Bluetooth Devices - Unify OpenScape S5 Base Bedienungsanleitung

Bluetooth

Registering Bluetooth devices

The distance between the handset in Bluetooth mode and the active Bluetooth device (headset
or data device) should not exceed 10 m.
¤
Device
are displayed . . . possible options:
Register device:
Display information about a device:
Repeat search:
Cancel search:
Editing the list of known (trusted) devices
Open the list
¤
known devices are listed, an icon indicates the type of device
If a device is connected, the relevant icon is shown in the display header instead of
Edit an entry
¤
to select entry . . . possible options:
View an entry:
De-register a Bluetooth device:
Edit name:
104
Downloaded from www.Manualslib.com
The registration of a headset overwrites a previously registered headset.
If a headset is to be registered that is already registered with a different device, this
connection must be deactivated before registering.
. . . use to select
OK . . . the search starts (may take up to 30 seconds) . . . the names of found devices
¤
Options
the Bluetooth device to be registered
to the list of known devices
¤
. . . use
name and device address are displayed
¤
Options
¤
Cancel
. . . use to select
Bluetooth headset
Bluetooth data device
. . . use to select
¤
View . . . the device name and device address are displayed
OK to go back
¤
Options
¤
Options
If an active Bluetooth device is de-registered, it may try to re-connect as a "non-
registered device".
manuals search engine
Bluetooth OK
Trust Device OK
to select a device, if applicable
Repeat Search OK
Bluetooth OK
Bluetooth OK Known Devices
Delete entry OK
Edit Name OK
Search for Headset / Search Data
. . . use to enter the PIN of
OK . . . the device is added
View . . . the device
Known Devices OK . . . the
OK . . . use
. . . use to edit name
.
Press
Save