Transferring Data - Unify OpenScape DECT Phone S5 Base Bedienungsanleitung

Transferring data

Data transfer using Bluetooth:
•
The computer has Bluetooth capability.
•
A USB data cable is not plugged in. If a USB data cable is plugged in during an
existing Bluetooth connection, the Bluetooth connection is interrupted.
¤
Launch the Gigaset QuickSync program on the computer.
The message Datentransfer läuft is shown on the display during data transfer between the
handset and PC. During this time, it is not possible to enter any data using the keypad and
incoming calls are ignored.
Carrying out a firmware update
¤
Connect the telephone and the PC using a USB data cable (
QuickSync Establish connection to the handset
¤
Start firmware update in Gigaset QuickSync . . . Information about this can be found in
Gigaset QuickSync help feature
The update process may take up to 10 minutes (not including download time).
Do not interrupt the process and do not remove the USB data cable.
The data are first downloaded from the online update server. The time required for this depends
on Internet connection speed.
The display on your telephone is switched off and the Message key
will flash.
Once the update is complete, your telephone will automatically restart.
Procedure in the event of an error
If the update procedure fails or the telephone no longer functions properly after the update,
repeat the update procedure:
¤
End the Gigaset QuickSync program on the PC
telephone Remove the battery (
¤
Carry out the firmware update again as described above
If the update procedure fails more than once or it is no longer possible to connect to the PC, carry
out the Emergency Update:
Additional functions using the PC interface
Remove the USB data cable from the
p. 77) Replace the battery
p. 79) Launch Gigaset
and the Talk key
105