Installing The Appliance - Blaupunkt 5CG 24010 Montage- Und Gebrauchsanweisung

Page 51
Start-up

Installing the appliance

Prior to installation, check whether the
door hinge is on the correct
side. If necessary, change the door hinge
(see "Changing the door hinge" on page 48).
For the installation, you will require a PH2
Phillips screwdriver.
1. Switch off the fuse for the designated
socket (220-240 V~ / 50 Hz). Then plug
the power plug into the socket.
2. Slowly and cautiously push the
refrigerator into the built-in cabinet.
When doing this, ensure that the side
to be opened is located as close to the
cabinet wall as possible.
(23
)
(18
)
3. Holes are pre-drilled in the outer edges
of the appliance door for attaching the
sliders (18). Screw the sliders to the
side to be opened using the short
screws (23).
4. Push the drag rails (20) into the sliders
(18). Close and open the cabinet door
to check whether it can be closed
completely and easily. If necessary,
correct the position of the refrigerator.
5. Open the door of the appliance and the
cabinet at the same time. Then mark
the optimum positions of the drag rails
inside the cabinet door.
6. Remove the drag rails from the sliders.
7. Screw the drag rails to the marked
positions on the inside of the cabinet
door using 2 short screws (23) each.
8. Press the covers (21) onto the drag rails.
(20
)
9. Unscrew the sliders again and push
them on the attached drag rails.
10. Screw the sliders to the appliance
door again.
(20
)
(23
)
(20)
( )
21