Operating The Keys; Switching On The Hob And Cooking Zones; Switching Off A Cooking Zone; Switching Off The Hob - Teka GKST 80 Gebrauchs- Und Montageanweisung

Operation
lights up
suitable for induction cooking

Operating the keys

The controls described here expect the pressing of a (selection) key to be
followed by the pressing of a subsequent key.
The next key will need to be pressed within 10 seconds, otherwise the
selection will be deleted.

Switching on the hob and cooking zones

1. Press the ON/OFF key
2. To select a cooking zone, press the power level display (as a key). The
stand-by dot
3. The sensor field
4. Immediately put cookware suitable for induction cooking onto the

Switching off a cooking zone

5. To select a cooking zone, press the power level display (as a key). The
stand-by dot
6. a) Press the sensor field
6. b) move the finger you have placed on the sensor field
6. c) Press the ON/OFF key

Switching off the hob

7. Press the ON/OFF key
Note:
The hob will switch off automatically after 10 seconds when all the cooking
zones are switched of manually (power setting 0) and no key/sensor field is
pressed afterwards.
appears and a short signal will sound. The stand-by dots will blink. The
controls are ready for operation.
stand-by dot of the cooking zone selected will light up.
power setting will be switched on.
........ Left .........................Power level 0
........ Middle ....................Power level 5
........ Right ......................Power level 9
See the section on „Worth knowing about the slider (sensor field)"
Select the respective cooking zone and then press the sensor field
to change a power setting or to switch on an additional cook-
ing zone.
Important: The corresponding stand-by dot must light up!
cooking zone. The pan recognition device will activate the induction coil.
The pot or pan will be heated up.
As long as no metal cooking pot is placed onto the cooking zone, the dis-
play will alternate between the power level set and the symbol
If no pot is placed on the cooking zone it will switch off after 10 minutes
for reasons of safety. Please refer to the Section on "pan recognition".
stand-by dot of the cooking zone selected must light up.
left to reduce the power setting to 0 or
the cooking zones are switched off).
irrespective of any settings.
(approx. 1 sec.) until the power setting 0
must be activated immediately afterwards. A
on the far right (0) or
. The entire hob will be switched off (all of
. The hob will be completely switched off,
GB
.
to the
25