Checking The Obstacle Detector; Connecting Accessories; Preparation - SOMFY KEASY L Handbuch

All manuals and user guides at all-guides.com
4. Deleting the handheld transmitter
The programmed handheld transmitters are deleted by overwriting the previously saved values.
You do this:
– by programming a new control button on the handheld transmitter,
or
– by programming a handheld transmitter with a new security code on the opener
(see "Setting the security code").
Note:
If one handheld transmitter is deleted, all handheld transmitters will be deleted which have been
programmed with the same security code or the same control button.

Checking the obstacle detector

When switching on the garage door opener for the first time and then at least 1x month:
• Place a suitable object at least 50 mm tall (e.g. block of wood) in the path of the garage door
(door close movement).
• Start the garage door opener.
– On approaching the obstacle, the garage door stops, moves up to the upper mechanical end
stop and then back to the programmed upper stop position.
– The opener light flashes in a one-second cycle.
• Restart the garage door opener to stop the flashing.
– If this is not the case, please contact the Service Line.

Connecting accessories

Preparation

Risk of electric shock
Before connecting accessories, pull out the mains plug.
Caution!
Connect only original accessories according to the manual. Potential-free contacts – do not apply
interference voltage!
• Remove the cover flap from the electronics (1).
• To connect the wires, remove the terminal strip (2).
Terminal assignment (3):
– a Pushbutton connection
– b Light barrier connection
– c Warning light connection
13