Error Message In The Display - hanseatic MC-IF7242H1B3C Gebrauchsanleitung

Page EN-26 Troubleshooting
Problem
The hob switches off
unexpectedly. You will
hear a signal, and an
error message (usually
a blinking timer display)
will appear in the sensor
field.
If these tips were not helpful, please contact our Service Centre (see page EN-27).

Error message in the display

Error code Possible problem
E1 E2
/ Wrong mains voltage
E3 E4
/ One of the heat sensors in the glass
ceramic hob measures excessive tem-
perature
E5 E6
/ Overheating electronics
F3 F6
/ , Temperature sensor error
F4 F7
/ ,
F5 F8
/
F9 FA
/ , Connection error between display and
FC FD
/ motherboard
Possible solutions/tips
Technical error. Make a note of the error message on the sensor field,
disconnect the hob from the power supply and contact our Service
Centre (see page EN-27).
Possible solutions/tips
Disconnect the hob from the power
supply and check that the mains volt-
age is correct. Only switch the power
supply back on when the mains voltage
is again normal.
Wait until the hob has cooled down.
Inspect the cookware. Then switch the
appliance back on again.
Wait until the hob has cooled down.
Then switch back on again.
Contact our Service Centre (see page
EN-27).