Cooking Zones And Sensors; Activating The Sensors; Cooking Zone Data; Pot Recognition - hanseatic MC-IF7242H1B3C Gebrauchsanleitung

Page EN-12

Cooking zones and sensors

Cooking zones and sensors

Activating the sensors

The hob has four cooking zones. A sensor is
assigned to each cooking zone.
Always activate the sensors with your entire
fingertip; not just the very end of the finger.
Each time the sensor registers a touch, you
will hear an acoustic signal.
Your finger and the sensors must be clean
and dry for the sensors to function properly.
The sensors may not be covered by objects.

Cooking zone data

Cookware
Cooking
dimensions
zone
in mm
Rear left 140–210
Front left 140–210
220/
Entire left
220×400
Rear right 160–210
Front right 160–210

Pot recognition

Pot recognition is installed in the cooking
zones. Pot recognition ensures that the cook-
ing zones will be activated only if there is a pot
with a ferromagnetic base or another object
made of the same kind of metal located there.
The cooking zone becomes inactive as soon
as the pot or the magnetic object is removed.

Switching the hob on and off

To switch
• on the hob, touch the On/Off sensor
(6) for a few seconds.
You will hear an acoustic signal.
All cooking zone displays and sensors will
illuminate.
• off the hob, touch the On/Off sensor
(6).
An acoustic signal will sound, and all indi-
cator lights with the exception of the resid-
max.
ual heat symbols '
output in W
2000/3000
If you do not press a sensor or do not
2000/3000
place suitable cookware on the cooking
zone within one minute of switching the
3000/4000
hob on, the hob will switch off automatically.
1800/2300
1800/2300
Switching the cooking zones/
areas on and off
Switching on/Selecting
Requirement: The hob is switched on.
1. Place a suitable pot on the desired cook-
ing zone/area (e.g. front right).
Make sure that the base of the cookware
and the cooking zone are clean and dry.
2. Touch the corresponding cooking zone
sensor; in this example, front right (5).
The heat setting in the cooking zone sen-
sor lights up and flashes (in this case the
reading shows '
88
8
8
Timer
H ' will go out.
88
8
8
Timer
(5)
0
', i.e. no heat output).
(6)