Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page EN-22
Installation
Installation
Important user information
The glass ceramic hob is intended to be fitted
in a kitchen worktop or similar fixture. If you
have the requisite skills, you can fit the hob
yourself. However, the electrical connection
must be carried out by authorised specialist
staff.
Requirements
(a)
(e)
(b)
(c)
(d)
(f)
(h)
(k)
(j)
(k)
(k)
(a)
(b)
(b)
(d)
(e)
(f)
(g)
(h)
(i)
(j)
(k)
(l)
(m)
Installation site
– The built-in furniture must have coverings
and the adhesives used must be heat-re-
sistant (100 °C). If this is not the case, this
can lead to deformation or detachment of
the covering surface.
– Do not install the hob directly next to a re-
frigerator or freezer. This will increase its
energy consumption unnecessarily due to
heat emission.
Minimum distances
Hob electronics must be able to cool down in
order to ensure safe operation. That is why
all minimum clearances must be adhered to
during installation:
(a) The distance between the hob and the
(b) To ensure sufficient cooling, the hob must
(g)
(k)
(i)
(c) The air vent below the hob must have a
(e) At least 5 mm of free space must be kept
≥ 760 mm
≥ 50 mm
≥ 20 mm
Air inlet
≥ 5 mm
590 mm
520 mm
60 mm
560–564 mm
490–494 mm
≥ 50 mm
≥ 30 mm
≥ 3 mm
extractor hood must be at least 760 mm.
be separated from the rest of the built-
in unit/oven by a horizontal fixing plate
made out of wood. A free space measur-
ing at least 50 mm in height must be kept
between the hob and the fixing plate.
Any side walls or drawers which are
present must be sawn out or dismantled
accordingly.
free space of at least 20 mm to ensure
the supply of cold air (d).
on the front of the kitchen cabinet/oven.
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
