Error Message In The Display - hanseatic MC-IV10241B2CC-A Gebrauchsanleitung

Problem
The cookware does not
heat up and the mes-
sage ' ' appears on the
display.
The hob switches off un-
expectedly. You will hear
a signal tone and an er-
ror message will appear
in the sensor field.
If these tips were not helpful, please contact our Service department (see "Service" on
page EN-26).

Error message in the display

Error code Possible problem
E1 / E2 Wrong mains voltage.
E3 / E4 One of the heat sensors in the glass
ceramic hob measures excessive tem-
perature.
Incorrect cookware.
E5 / E6 Overheating electronics.
F3–F8 Defective temperature sensor.
F9–FA Defective temperature sensor.
Possible solutions/tips
The cookware is not recognised because it is not suitable for induc-
tion hobs. Select suitable cookware (see "The right cookware" on
page EN-12).
The induction hob does not recognise the cookware because it is too
small for the selected cooking zone/mixed zone or because it is not
centred on the cooking zone/mixed zone.
Technical error. Make a note of the error message on the sensor field,
disconnect the hob from the power supply and contact our Service
department (see "Service" on page EN-26).
Troubleshooting
Possible solutions/tips
Disconnect the hob from the power
supply and check that the mains volt-
age is correct. Only switch the power
supply back on when the mains voltage
is again normal
Wait until the hob has cooled down.
Inspect the cookware. Then switch the
appliance back on again.
Wait until the hob has cooled down.
Then switch back on again.
Contact our service department (see
"Service" on page EN-26).
Page EN-25