Switching On And Off; Sharpening Drills; Sharpening Picks And Chisels - Parkside PSS 65 A1 Originalbetriebsanleitung

Switching on and off

Ensure that the mains voltage
matches the specifications on the
rating plate.
Connect the equipment to the mains.
1. To switch on, press the "I" On switch
and the device starts up (see
2. To switch off, press the "0" off switch
and the device switches off (see
After switching on the device, wait until the
device has reached its max. speed. Only
then must you start with the grinding.
The disk will continue to
run after the equipment is
switched off. There is a risk
of injury.
Test run:
Before starting work and after each
change of grinding disk, carry out a test
run of at least 60 seconds with no load.
Switch off the equipment immediately if the
disk runs lumpy, substantial vibrations oc-
cur, or abnormal noises are generated.

Sharpening drills

Drills with a diameter of 3-10 mm can be
sharpened.
1. Mount the selected sharpener
(see Mounting sharpener).
2. Remove the drill holder (14) from
the sharpener.
3. Insert the drill into the drill holder
(14).
4. Insert the drill holder (14) into the
adjusting device (15).
5. Push the drill to the front into the
6. Using the knurled nut fasten the
7. Remove the drill holder (14) and
3). 8. Check the alignment of the drill.
3).
9. Switch the device off and grind
10. Switch the device off and wait for
11. Remove the drill holder (14)
12. Switch the device off and grind
13. Switch the device off and wait for

Sharpening picks and chisels

1. Mount the selected sharpener
2. Place the blade on the tool table
3. For small picks, use the spacer
4. Select the angle according to the
V-nut up to the metal stop. The
cutting edges of the drill must fit
closely to the metal surfaces.
drill for drill-fastening (12).
insert it into the rotatable drill
mount (11).
The cutting edges of the drill must
be touching the grinding wheel
(10).
the drill.
the grinding wheel (10) to stop.
and insert it into the rotatable
drill mount (11) by rotating in
by 180°. Using the same adjust-
ment, you can grind the opposite
cutting edge of the drill.
the drill.
the grinding wheel (10) to stop.
(see Mounting sharpener).
(6) so that the end to be sharp-
ened fits closely to the edge of
the tool table (6). The magnetic
holder (5) keeps the blade in po-
sition.
(4).
existing bevel angle (angle of the
bevelled edge).
GB
11