Mounting/Setting The Guide Fence; Connecting The Sawdust Extraction Appliance; Operation; Switching On And Off - Parkside PHKS 1350 C2 Originalbetriebsanleitung

WARNING!
► The arrow on the saw blade
pond to the arrow showing the direction of
rotation (running direction shown on the
device) .
■ Ensure that the saw blade
rotational speed of the tool .

Mounting/setting the guide fence

♦ Loosen the wing screw
fence into the guide fence slot
♦ Set the desired cut width with the help of the
scale on the guide fence
arrow in the base plate
Fig. B: Cutting width 3 cm
♦ Retighten the wing screw
Connecting the sawdust extraction
appliance
♦ Attach the adapter for dust extraction
chip ejector .
♦ Connect an approved dust and chip extraction
device .
■ 10 │ GB │ IE │ NI │ CY
must corres-
is suitable for the
and insert the guide
.
and the marking
(see also Fig . B) .
.
to the

Operation

Switching on and off

Switching on
♦ Push the safety lock-out
and keep it pressed .
♦ Press the ON/OFF switch
running you can release the safety lock-out
Switching off
♦ Release the ON/OFF switch

Setting the cutting angle

You can select the cutting angle with the help of the
cutting angle scale
.
■ Release the wing screw on the cutting angle
preselector , set the desired angle on the
cutting angle scale
wing screw .

Setting the cutting depth

NOTE
► We generally recommend setting the cutting
depth to approx . 3 mm more than the thick-
ness of the material . This ensures that you
achieve a clean cut .
♦ Release the locking screw
cutting depth on the cutting depth scale
then re-tighten the locking screw

Working with the circular saw

1 . Switch on the device – as described in
˝Switching on and off˝ – and then place it with
the front edge of the base plate
material .
2 . Align the machine using the guide fence
by using a marked line .
3 . Hold the machine in both hands using the
handles and saw by exerting an even pressure .
to the left or right
. Once the saw is
.
and then re-tighten the
, set the desired
and
.
on the
or
PHKS 1350 C2
.