Herunterladen Inhalt Inhalt Diese Seite drucken

Refilling Oil; Connecting To A Compressed Air Source; Operation; Compressed Air Ratchet - Parkside PDRS 27 A1 Originalbetriebsanleitung

Druckluft-ratschenset
Vorschau ausblenden Andere Handbücher für PDRS 27 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4

Refilling oil

To ensure that the tool remains operational for
a long time, the tool must have a sufficient fill of
pneumatic oil .
You have the following options:
Attach a maintenance unit with an oiler to the
compressor .
Install an add-on oiler in the compressed air
line or the compressed air tool .
Add 3–5 drops of pneumatic oil into the con-
nector nipple
every 15 minutes of operation .
Connecting to a compressed air
source
NOTE
Before connecting the compressed air source,
the correct working pressure (6 .3 bar)
must be fully reached, and
make sure that the trigger is in the upper
position .
Use only connection hoses with an internal
diameter of at least 9 mm .
Use only filtered, lubricated and regulated
compressed air .
Screw the connector nipple
. Tighten the connection with a pair of pliers .
Attach the tool to a compressor by connecting
the connector nipple
of the compressed air source .
28 
GB │ IE
into the air inlet
with the supply hose
CAUTION!
Ensure that the compressed air hose is
firmly attached . A loose hose can thrash
about uncontrollably causing grave danger .
Likewise, ensure the firm seat of the two screw
connections between the coupling piece and
the appliance .
The compressed air source must be equipped
with a pressure reducer so that you can regu-
late the air pressure .

Operation

Compressed air ratchet

Fit the required plug-in attachment
or the extension piece
retainer
.
Set the correct rotational direction on the turn
bolt
:
R = anticlockwise
F = clockwise
Fit the plug-in attachment onto the screw head .
NOTE
The connection with the compressed air
source is made using a flexible compressed
air hose with a quick coupler .
You will reach the best performance of your
ratchet wrench with a compressed air hose
LW 10 mm .

Switching on and off

Switching on:
Press the trigger
Switching off:
Release the trigger
When you have finished working, disconnect
the tool from the compressed air source .
,
+
onto the square
to turn the appliance on .
.
PDRS 27 A1

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis