Use
Switching on and off
Switching on
♦
Push the ON/OFF switch
the appliance on .
The LED work light
appliance is switched on to light up the working
area in low light conditions .
NOTE
►
The LED work light
the dust extraction unit
Switching off
♦
Push the ON/OFF switch
switch the appliance off .
Selecting oscillation speed
♦
Use the speed adjustment wheel
required oscillation speed .
Level 1: low speed
Level 6: high speed
NOTE
►
The required speed depends on the material
being worked and on the working conditions
and can be determined through practical tests .
■
10
│
GB │ IE │ NI
forwards to switch
lights up when the
can only be used when
is not fitted .
backwards to
to set the
Maintenance and cleaning
WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
■
Do not use any sharp objects to clean the
appliance . Do not allow any liquids to get into
the appliance . This can damage the appliance .
■
Clean the appliance regularly, preferably
immediately after completion of the work .
■
Use a soft, dry cloth to clean the housing .
Never use petrol, solvents or cleansers which
can damage plastic .
■
A vacuum cleaner is required for thorough
cleaning of the appliance .
■
Ventilation openings must never be obstructed .
■
Remove any sanding dust stuck to the appliance
with a brush .
■
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level is
between 50% and 80% . The optimum storage
environment is cool and dry .
NOTE
►
Replacement parts not listed (such as carbon
brushes, switches and replacement batteries)
can be ordered via our service hotline .
PAMFW 20-Li A1