Technical Specifications; Safety Instructions; Symbols And Icons - Parkside PDOS 200 B2 Originalbetriebsanleitung

GB IE

Technical specifications

Nominal input voltage ......230 V~, 50 Hz
Power consumption ..200 W (S2 30 min)*
Safety class .......................................... I
Mechanical rating .......................... IP 20
Measurement idling speed n
Velocity v .......................... max. 23 m/s
0
Grinding disc
Outer diameter ................... Ø 150 mm
Bore hole .......................... Ø 12.7 mm
Thickness .................................20 mm
Hardness ....................................... P5
Grain size ................................ 36/80
Speed n0 ...................max. 4500 rpm
Working speed ................ max. 35 m/s
Weight (incl. accessories) .. approx.
Sound pressure level
(L ) ....................... 80 dB(A); K
PA
Sound power level (L
measured .............. 93 dB(A); K
Vibration total value (a
* A break is introduced after 30 minutes of
uninterrupted operating duration until the de-
vice temperature differs 2 K (2°C) less than
room temperature.
Noise and vibration values have been
determined according to the standards and
regulations mentioned in the declaration of
conformity. Technical and optical changes
may be undertaken in the course of further
development without notice. All dimen-
sions, references and information in this
instruction manual are therefore not guar-
anteed. Legal claims made on the basis of
the instruction manual can therefore not be
considered as valid.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
22
... 2950 min
0
6.7 kg
=3 dB
PA
)
WA
=3 dB
WA
) ......... 2.5 m/s
h
also be used for a preliminary exposure
assessment.
Warning! The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
-1
which the power tool is used.
Safety precautions aimed at protect-
ing the user should be based on
estimated exposure under actual
usage conditions (all parts of the
operating cycle are to be consid-
ered, including, for example, times
during which the power tool is
-1
turned off and times when the tool
is turned on but is running idle).

Safety Instructions

WARNING!
When using power tools, observe
2
the following basic safety measures
for the prevention of electric shocks
and the risk of injury and fire.
Please read all these instructions
before using the electric tools and
please keep the safety instructions.

Symbols and icons

Symbols in the manual:
Warning symbols with in-
formation on damage and
injury prevention.
Instruction symbols (the instruction is
explained at the place of the excla-
mation mark) with information on
preventing damage.
Help symbols with information on
improving tool handling.