For certain work, the sawblade
can also be inserted after turning
through 180°.
Operating the sabre saw
1. Before switching the appliance on, en-
sure it is not in contact with the work-
piece.
2. Turn the appliance on.
By using the on/off switch (
can progressively control the stroke rate.
Gentle pressure: low stroke rate.
Greater pressure: higher stroke rate.
The on/off switch cannot be locked.
3. Place the footplate (
workpiece.
4. Cut with a uniform forward motion.
5. After completion of the work, fi rst
switch off the device and then remove
the blade from the saw cut.
Sawing
Wear eye protection.
•
Use only undamaged sawblades in
perfect condition. Only use metal saw-
blades for metalworking.
•
Ensure your stance is stable and hold
the appliance tightly with both hands
and away from your body.
•
Before sawing the workpiece, check
for hidden foreign objects such as
nails, screws. These must be removed.
•
Plunge cuts may only be made in soft
material such as wood or plaster-
board.
Plunge cuts
Risk of kickback! Hold the
device fi rmly.
10) you
17) on the
1. Place the device with the bottom edge
of the footplate (
ece.
2. Insert the saw blade (20) in the workpi-
ece by tipping the device forward until
the device is vertical.
3. Continue sawing along the desired cut-
ting line.
Selection of sawblade
Wood sawblade
Metal sawblade
Plunge sawblade
Motor unit with
multifunction tool
PKGA4
Wear a protective mask during
grinding work.
Changing the tool
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
Ensure that the tool holder (29) is
tightly screwed in to ensure you can
safely mount and use all the sup-
plied tools (30/32/33).
1. Push the lever (27) for tool unlocking
upwards as far as the stop.
2. Place the desired tool (30/32/33) be-
low the tool holder (29) on the arbors
GB
17) on the workpi-
for wood, plastic, plaster-
board
for metal sheets, profi les
and tubes
for soft materials like
wood or plasterboard
IE
39