Connecting Dust Extraction; Sanding; Selection Of Sanding Sheet; Motor Unit With Sabre Saw Attachment Pkga3 - Parkside PKGA 20-Li C2 Originalbetriebsanleitung

GB IE

Connecting dust extraction

You can reduce dust production during sand-
ing by attaching a dust extraction system.
1. Push the adaptor (24) into the opening
on the multi-sander attachment (22) as
far as the stop.
2. Connect a dust extractor suction hose
to the adaptor (24).
If necessary, you can connect the suc-
tion hose of a vacuum cleaner with-
out reducer (25) to the adapter (24).

Sanding

• Use a dust extraction system when sand-
ing with the multi-sander attachment.
• Move the appliance against the work-
piece once it is switched on.
• Clean the sanding plate before you at-
tach a sanding sheet.
• Only work with sanding sheets in per-
fect condition to achieve good sanding
results.
• Work using low and even pressure.
This protects the appliance and the
sanding sheet.
• Do not use the same sanding sheet to
sand different materials (e.g. metal
and then wood).

Selection of sanding sheet

Grain size P Application
for pre-sanding rough wood
P 60
surfaces
P 80 / 120 for plain sanding
for fi ne sanding of primed
P 240
and painted surfaces
38
Motor unit
with sabre saw
attachment PKGA3

Installing/changing the blade

Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
Wear gloves when handling the
sawblade. In this way, you avoid
injury from cuts.
Caution, risk of Injury!
- Do not use any blunt or bent
blades or blades which are
damaged in any other way.
- Always insert a suitable saw-
blade.
An overview of appropriate blades
can be found in "Spare Parts/Ac-
cessories".
Installing the blade:
1. Push the lever (18) for sawblade un-
locking downwards as far as the stop
and keep it held down. Push the saw-
blade shaft (19/20) into the sawblade
mounting slot.
2. To unlock, release the lever (18), it will
return to the initial position.
3. Check that the sawblade is secure by
pulling on it.
Removing the sawblade:
4. Press the lever (18) for sawblade un-
locking upwards as far as the stop and
then pull the sawblade out of the saw-
blade mounting.