Attaching/Removing Sanding Sheet; Sanding; Selection Of Sanding Sheet; Scraping - Parkside PKGA 20-Li C2 Originalbetriebsanleitung

GB IE
(28). You may need to rotate the un-
locked tool holder (29) as far as need-
ed to allow you to place the desired
tool (30/32/33) onto the arbors (28).
12 different positions are possible.
3. Rotate the tool holder as required until
it is fi rmly in place.
4. Push the lever (27) for tool unlocking
forwards again. The tool holder is
fi xed to the tool.
Attaching/removing sanding
sheet
The delta sanding plate (30) is fi tted with
Velcro for rapid attachment of the sanding
sheet.
Attaching sanding sheet
1. Press the sanding sheet (31) evenly
onto the delta sanding plate (30). En-
sure that the holes in the sanding sheet
are placed above the openings in the
sanding plate.
Removing sanding sheet
2. Simply pull the sanding sheet (31) off
the delta sanding plate (30).

Sanding

• Move the appliance against the work-
piece once it is switched on.
• Clean the sanding plate before you at-
tach a sanding sheet.
• Only work with sanding sheets in per-
fect condition to achieve good sanding
results.
• Work using low and even pressure.
This protects the appliance and the
sanding sheet.
• Do not use the same sanding sheet to
sand different materials (e.g. metal
and then wood).
40

Selection of sanding sheet

Grain size P Application
for pre-sanding rough wood
P 60
surfaces
P 80 / 120 for plain sanding
for fi ne sanding of primed
P 240
and painted surfaces

Scraping

• Use a high oscillation rate when scrap-
ing.
• Work using low pressure and at a low
angle in order not to damage the sub-
strate material.