Opera�Ng Controls - LR-Cal LSP 1000-H Bedienunganleitung

3.1 Opera�ng controls
(1)
(2)
(3)
(1) Locking lever
(2) Pressure port p1 (for reference or unit under test)
(3) Reservoir (for the opera�ng fluid)
(4) Pressure port p2 (for reference or unit under test)
(5) Slot in the housing, e.g. for placement of gaskets and adapters
(6) Priming pump knob (opera�on of the priming pump)
(7) Knurled nut of the priming pump (to be noted at ini�al prepara�on of the pump only)
(8) Indica�on of posi�on of the piston
(9) Star handle (opera�on of the spindle pump)
In the following instruc�ons, the opera�ng controls are niden�fied with the above men�oned
numbers in brackets.
The device is equipped with a sinter filter (brass) in the base of the reservoir and with stainer dirt
collectors (st.st. 1.4401) in the pressure ports p1 and p2. This reduces considerable the risk of
material pollu�on of the opera�on fluid. If the pump is used with mineral oil, the sinter filter in
the reservoir has to be dismounted (using a flat screw driver).
DRUCK & TEMPERATUR Leitenberger GmbH • Bahnhofstr. 33 • D-72138 Kirchentellinsfurt • GERMANY
Tel. +49 (0) 7121-90920-0 • Fax +49 (0) 7121-90920-99 •
Druckvergleichsprüfpumpen
Pressure comparison pumps
DT -Info@Leitenberger.de •
29
LR-Cal LSP-H
LR-Cal LSP-H
www.druck-temperatur.de
MANUAL
(4)
(5)
(6)
(7)
(8)
(9)