RADEMACHER RolloPort S2 Bedienungsanleitung Seite 53

Conclude programming
IMPORTANT
Please note: this concluding step must be carried out,
otherwise the information stored will be lost.
Method 1: Carry out this method without fail after the reference run.
1. After the reference run,
press „-" (press several
times if necessary) until
„1" is displayed.
Method 2: After all other settings
1. After completing any
setting, press „P"
for 5 seconds.
NOTE
You can conclude the programming in two ways:
2. Keep „P" pressed
for 5 seconds.
2. „0" will be displayed at
regular intervals in order
to conclude the program-
ming and set the door ope-
rator into an idle state.
3. „0" will be displayed at
regular intervals in order to
conclude the programming
and set the door operator
into an idle state.
GB
53