RADEMACHER RolloPort S2 Bedienungsanleitung Seite 49

Adjust power limiting as required
NOTE
The door operator is preset to stage 3 by the supplier. If
required (e.g. if the power level is too low) you can
subsequently adjust the power limiting setting.
1. Press „+" (if necessary
press several times) until
„4" is displayed.
Low
4. Press „P", in order
to store the setting.
After a resetting of the power level, it is absolutely necessary to repeat the reference run for power
limiting and to conclude the programming again.
During the reference run there is a risk of injury as the door operator develops extremely strong
forces.
If the power level is too low, the door
movement will be impaired, particularly if the
mechanical structure of the door is not well
balanced.
2. Press „P", the display
shows „7" (stage 3).
Power level
Factory setting
5. IMPORTANT
Repeat reference run
for power limiting
(refer to page 48).
3. Press „+" or press „-"
to select the stage.
High
6. Conclude programming
(refer to page 53,
method 1).
GB
49